RealSimGear products work well with the following Reality-XP products for X-Plane, P3D and FSX

After a successful install of the RealityXP software, you should now see The RealityXP GTN or GNS in the plugins menu.

Step 1: Go to the plugins menu of XPlane 11 and select either the RealityXP GNS or GTN depending on which hardware you have.

Step 2: Hover your mouse over GTN 1 or GNS 1 this will bring up a menu to configure the system you wish to control. Hovering over GTN 1/GNS 1 will control COM 1/ NAV1 functions. If you wish to configure RealityXP to control COM 2/ NAV 2 select GTN 2 or GNS 2.

Step 3: In the example below we are configuring the GTN 750. Click GTN 750 1 in the sub-menu. This should load the GTN750 gauge.

Step 4: In the GTN 750 1 submenu click on "Popout window" this should add a border around the GPS gauge and now allow for you to drag the window to the RealSimGear GPS device screen and maximize the window.

Step 5: Close Xplane and run the RealSimGear Plugin installer. If you have already installed the RealSimGear plugin simply rerun the installer file and follow the onscreen prompts as this will remove the bezel and finalize the connection between the RealityXP software and the RealSimGear hardware.

Step 6: After reinstalling the RealSimGear plugin, you can now load back into the aircraft and you should be good to go at this point.

Note: By default, the RealSimGear GNS430 is configured to be NAV2.  If you wish to use this as NAV1, please email us for simple instructions on how to change this.

Did this answer your question?