Download and install the RealSimGear plugin for your flight simulation software.

Connect the cables

Connect the HDMI, USB and power cables.  Turn on your PC and the display will show a second windows or mac desktop.  The image displayed on the GNS530 will be inverted, to correct this you will need to adjust the display settings.

Configure the display

With the cables connected, open the Windows Display settings.  You should now see a smaller box that represents the GNS530 display.  If you are unsure, click the 'Identify' button to confirm which display is associated with the GNS530 device.

Click on the GNS530 display (number 2 in this example) and change the display setting for the smaller display to “Landscape / flipped”, leave the resolution set to whatever Windows says is recommended, usually 1280x720.

It is usually best to 'place' the GNS530 display below and to the center of your primary display. This makes it easy to adjust the GNS530 to exactly fill the display however if you have multiple other displays, this positioning may need to be modified.

Remove the bezel graphics

*Note if you used the new X-Plane installer, you do not need to perform the following bezel process.

To hide the bezel graphic and ensure the GNS530 only displays the screen content you need to override the default settings.

If you are using the default X-Plane GNS530

Download the bezel replacement file, and place it in the following folder.  Note the file must be named exactly as "Garmin_530_2d.png"

..\X-Plane\Resources\Bitmaps\Cockpit\Radios\GPS FMS

If you are using the Reality-XP GNS530

Please see these additional instructions for how to configure RealSimGear products to work with Reality-XP.

Position the screen and test

Start X-Plane and load the default Cessna 172SP.  With the default 3D cockpit view selected, click on the virtual GNS530 screen so that it ‘pops out’. Note the background may look strange, look for the small rectangle in the upper right and click this to make the window appear with the white bar at the top.

Now position the window so that it fully fills the GNS530 screen.  If you position the GNS530 display below your primary display, just drag it down so the only the white bar is visible in your primary display.  You may need to adjust the width/height of the popped out window slightly.

Try pressing the buttons on the GNS530 and you should see screen change.  If you don’t see anything changing, you can check that the GNS530 is connected by checking the connection status window in "Plugins -> RealSimGear GNSx30 -> Connected Hardware". 

Your device should appear in this window, and the message/command items will change when you press the buttons or turn the knobs.

Not working or further questions? Please take a look at these additional trouble shooting steps.

You can also check out this video from X-Force PC that describes the complete setup process

Did this answer your question?